A road is a layered system: each layer spreads wheel loads so the soil below is never overstressed. In India, flexible pavements are designed to IRC 37 using design traffic in million standard axles (msa) and the subgrade CBR; rigid concrete pavements follow IRC 58. The MoRTH Specifications for Road and Bridge Works (the 'Orange Book') set materials, workmanship and test frequencies for every layer.
From bottom up, a typical flexible pavement has a compacted subgrade (500 mm, 97% of maximum dry density), granular sub-base (GSB) for drainage and load spread, wet mix macadam (WMM) base, then a prime coat, dense bituminous macadam (DBM) and a bituminous concrete (BC) wearing course bonded with tack coats. A rigid pavement replaces the bituminous layers with dry lean concrete (DLC) and pavement quality concrete (PQC), typically M40, with dowel bars at transverse joints and tie bars at longitudinal joints.
Good roads are won on compaction, drainage and temperature. Check field density on every layer, keep camber (about 2–2.5% for bituminous surfaces) so water runs off, and lay bituminous mixes within the specified temperature range — a cold mix will never compact. Side drains, culverts and shoulders matter as much as the carriageway: water entering the base is the main reason roads fail early.
Subgrade compaction
97% MDD
Bituminous camber
~2–2.5%
PQC grade (typical)
M40
Remember on site
- Flexible pavements: IRC 37 using msa and subgrade CBR; rigid pavements: IRC 58
- Layers: subgrade → GSB → WMM → prime → DBM → tack → BC
- Compaction, camber, drainage and laying temperature decide pavement life
Check yourself
Which IRC code is used to design flexible pavements?
What does 'msa' stand for in pavement design?
Which layer is the top wearing course in a typical bituminous road?
What is the purpose of a prime coat?
What are dowel bars used for in a concrete pavement?
What is the most common cause of early road failure?
