Sign in to save & sync
Sign in

Roof & wall sheeting

Sloped roof area, number of sheets, screws and ridge

Explanation in

Roof sheet area

0

m²

Sloping length (each side)
0 m (0 ft)
Sheets
0 nos of 0 m (0 ft)
Purlin lines
0
Self-drilling screws
0 nos
Ridge cap
0 m (0 ft)
Rise to ridge
0 m (0 ft)

How we got this

  1. 1

    Sloping length

    Formula
    √((span/2 + overhang)² + rise²)
    Your numbers
    √(0² + 0²)
    Answer
    0 m (0 ft)
  2. 2

    Area

    Formula
    2 × sloping length × length
    Your numbers
    2 × 0 × 0
    Answer
    0 m² (0 ft²)
  3. 3

    Sheets across

    Formula
    length ÷ cover width
    Your numbers
    0 ÷ 0
    Answer
    0
  4. 4

    Sheets down slope

    Formula
    (slope − lap) ÷ (sheet − lap)
    Your numbers
    (0 − 0) ÷ (0 − 0)
    Answer
    1
  5. 5

    Total sheets

    Formula
    2 × across × down × (1 + waste)
    Your numbers
    2 × 0 × 1 × 1
    Answer
    0 nos

The theory behind it

Method used: Sloped area ÷ sheet cover

Each half of a gable roof is a rectangle: shed length × sloping length. Sheets run down the slope; the number across = length ÷ effective cover width, and the number down the slope = sloping length ÷ (sheet length − end lap). Self-drilling screws go into every purlin at about 5 per sheet width.

Assumptions used

  • •Profiled sheets (Galvalume / colour-coated 0.45–0.50 mm TCT): effective cover usually 1.0–1.07 m.
  • •End lap 150 mm for slopes flatter than 1 in 4, side lap one corrugation.
  • •Screws ≈ 5 per sheet per purlin line (more at the edges in high-wind zones).

Codes & references

  • IS 277 — Galvanised steel sheets
  • IS 15961 — Hot-dip aluminium-zinc coated sheets
  • IS 875 (Part 3) — Wind loads
History

Estimates for guidance only. Confirm quantities with your site engineer.

© 2026 SiteMate. All rights reserved.